 |
- Improves Picture
and Sound Quality Level 4 Power Cleaning and Filtration
eliminates common symptoms of contaminated power (including loss of
detail, pops, hisses, hums and visual artifacts) and allows your A/V
equipment to perform up to its full capability.
- Monitors Incoming Line
Voltage and Provides a Visual Indication of Power Level
Panamax’s patent pending AVM™ circuitry continuously
monitors the incoming power as displayed on the digital voltmeter.
In case of an undervoltage or an overvoltage, a flashing red
lightning bolt will be displayed in the voltmeter, and power to the
connected equipment is automatically turned off if either of these
conditions is detected. When voltage returns to a safe level, power
to the equipment is automatically reconnected.
- Reduces
Cross-Contamination Between Components
The M5300-PM is designed
to provide noise isolation between 5 isolated outlet banks
(including 1 bank with 2 high current outlets) so that any noise
created by an A/V component cannot contaminate the power going to
equipment plugged into another outlet bank.
- Clean Power Level 4
Improves picture and sound quality by
eliminating noise across the entire AC bandwidth. 40% more efficient
at eliminating noise than Clean Power Level 3.
- AVM (Automatic Voltage Monitoring)
Protects equipment against
prolonged over/under voltages by disconnecting the power and
reconnecting it when safe power returns.
- High Current Outlets
2 outlets for equipment with high power
demands (Amps/Subwoofers).
- USB Charger
Convenience charger for mp3 players, cell phones,
and other small electronics.
- Gaming LAN Port
Easy access to LAN port on front panel. Perfect
for online gaming.
- 5 Isolated Outlet Banks
Isolating outlet banks from one another
prevents noise contamination between components.
- 12 Volt Trigger
Allows source equipment to activate or
deactivate the outlets on the M5300-PM.
- Power Sequencing
Guards against blown fuses and potentially
damaging speaker thump by automatically powering outlets on and off
in sequence.
- 11 Outlets
5 Always On, 4 Switched, 2 Switched High Current.
|
 |
AC Power:
- Under-voltage shutoff:
90 VAC ± 2 VAC
- UL1449 Suppression
Rating: 330V
- Total Current Capacity:
15 A
- Thermal Fusing Yes
Protection Modes: L-N, L-G, N-G
- Peak Impulse Current:
72,000 Amps
- Over-voltage shutoff:
142 VAC ± 8 VAC
- Line Voltage: 120V,
60Hz
- Initial Clamping Level:
200V
- Energy Dissipation:
2125 Joules
- Catastrophic Surge
Circuit: Yes
EMI/RFI Noise
Filtration:
- Banks 1, 2, 3, 4:
80 db, 100 KHz &minus 2 MHz
- Bank 5, High Current
Outlets: 60 db, 100 KHz − 2 MHz
DC Trigger Input:
- Voltage and Polarity:
3 - 24V DC, bidirectional
- Jacks:
3.5mm (1/8") mono mini-plug
- Current Requirement:
4.6 mA @3V, 58 mA @24V
DC Trigger
Output:
- Positive = Tip,
Negative = Ring Pass through:
no delay
LAN Circuits:
- Wires Protected:
8-Wires
- Connectors:
RJ-45
- Compatibility:
10/100bT
- Clamping Level:
52V
USB Circuit:
- Power Delivery:
500 mA @ 5VDC
- Jacks:
USB-A
Telco
Protection:
- Wires Protected:
2-Wire, Pins 4 & 5
- Suppression:
Modes Metallic & Longitudinal
- Fuseless/Auto-resetting:
Yes
- Connectors:
RJ-11
- Clamping Level:
260V
- Capacitance:
30pf (approx.)
Universal Coax
Protection:
- Shielded:
Yes
- Insertion Loss:
< 0.5 dB
- HD 1080 i/p Ready:
Yes
- Frequency Range:
0 MHz - 2.2 GHz
- Connections:
Female "F", Gold Plated
- Clamping Level:
75V
- Bidirectional:
Yes
|
